Repotting 2019 Lets show naked bottoms

Messages
1,654
Reaction score
2,539
Location
Belgium
Yes, its that time of year again. When the witch hazel blooms and some early birds start to show there feathers...
IMG_20190213_173442.jpg
IMG_20190223_173659.jpg
... its time to be prepared...
IMG_20190223_153028.jpg
IMG_20190223_153030.jpg
having the bags of akadama and bims (pumice) sifted and graded, some pots ready, ... fingers start to itch to dig down in the soil and find whatever nature created. Due to time constraints i was limited last year to only do the necessary repottings. Now time is still limited but we can catch sleep later...

Purpose of this thread is threefold. It's a documentation for myself to scroll back to whenever i forget what is in the pot and to be able to look when i repotted a certain tree. I also like reading and viewing repottings from others so i pick some tips and tricks down the road. I hope someone out-there loves repotting as much as i do so the third thing i want with this post is create some joy.
 
Step 1: find tree
IMG_20190223_145402.jpg
step 2: find and wire pot
IMG_20190223_145943.jpg
Step 3: prepare clips for the mesh. (They are easier to work with than the butterfly method. Easier to re-use, compact storage, less wire needed, less wire in the pot so more room for growing medium)
IMG_20190223_145951.jpg
Step 4: bend legs to match the pot-hole.
IMG_20190223_150054.jpg
IMG_20190223_150106.jpg
step 5: place mesh and clip from inside, loose the loose ends
IMG_20190223_150200.jpg
IMG_20190223_150223.jpg
 
Put drainage layer in pot
IMG_20190223_150314.jpg
Take tree out of pot. Smell and look at the roots. Are they happy? Different species have a different smell. When rotted you will notice and question yourself if you need to adjust watering habits or use other medium.
IMG_20190223_150849.jpg
IMG_20190223_150853.jpg
Dig down from above and make sure you see the nebari. This way you know where you need to stop if you get carried away cutting from the bottom.
IMG_20190223_151010.jpg
remove excess roots from below, this way you 'climb up'. When to stop depends on the species, health of the tree and what your goal is.
IMG_20190223_151109.jpg
Cut the bottom flat, cut half of an inch or an inch from the sides to remove turning roots. Start to even out the nebari. Remove roots that are too high.
IMG_20190223_151721.jpg
IMG_20190223_151744.jpg
Inspect result. Flat bottom, enough roots to survive, cut back to ramify and allow new soil.
IMG_20190223_152103.jpg
Check pot
IMG_20190223_152146.jpg
Depending on the goal you can cut back further and / or shoehorn it in the pot, or find a bigger pot.
 
In this case i took the original pot. Prepare with drainage layer.
IMG_20190223_152927.jpg
Put the medium in the pot in the middle on a pile...
IMG_20190223_153047.jpg
Place and turn the tree in.
IMG_20190223_153156.jpg
Where you want the roots depends on the species and the goal. Remember roots will not grow when they dry out often. They will not grow when they are soggy all the time. Post of the time a finger of soil above the roots is good. Depending on you soilmix and top cover. The more you leave on top of it the more roots will emerge higher than the desired nebari.
IMG_20190223_153204.jpg
Wire the tree firmly. After the obvious soil medium this is the most important part. I used the 5 wire trick from @markyscott (i think, i'm not sure and i don't find the nice tutorial)
IMG_20190223_153240.jpg
IMG_20190223_153718.jpg
Fill the rest with medium and work it in.
IMG_20190223_154018.jpg
water
IMG_20190223_154025.jpg
until clear
IMG_20190223_154049.jpg
 
For smaller trees or trees with the nebari high in the pot, or when you want to create optimal conditions to form roots, covering with sphagnum is a nice solution.
Rub the moss trough the biggest sieve, soak it in water so it doesn't fly around.
IMG_20190223_154154.jpg
Top-dress with a fine layer.
IMG_20190223_154330.jpg
Select next tree
IMG_20190223_154206.jpg
 
Chaenomeles
IMG_20190223_162843.jpg
IMG_20190223_164635.jpg
I found this little buggers. I had seen some last year but not in this amount. Otiorhynchus sulcatus (or Black Vine weevil). I know they are around because i saw lots of them when i sowed my grass years ago. Since then i planted a hedge of Taxus to be sure they stay around :eek:. I have some trees that are slowing down and i think this buggers might be one of the causes. I will use Steinernema Kraussei in a few months so i hope it works...

If someone knows a better solution i would be happy to hear.
IMG_20190223_163636.jpg
 
Favorite tree (prunus incisa kojou no mai) of my oldest daughter. She helped with trimming, wiring and repotting for a few years now. I hope the tree will reward us with nice flowers once again this year.
IMG_20190223_165033.jpg
IMG_20190223_171354.jpg
 
Acer buergerianum straight as an arrow to have a scarless lower trunk for a broom-like tree in a distant future.
IMG_20190224_150023.jpg
Full of roots
IMG_20190224_150704.jpg
Forgot about that chunk of wood (good thing i took pictures this time)
IMG_20190224_150855.jpg
Cleaning roots
IMG_20190224_152001.jpg
IMG_20190224_152005.jpg
IMG_20190224_152012.jpg
On the board again
IMG_20190224_152107.jpg
This tree does grow rather slow for a buergerianum. Stopped messing with the roots last year but still not the most happy tree. This stalling is something i noticed with other trees on a board as well. Might be coincidence. I've put the tree on pure akadama now. The other mix was used last repot because i ran out of the good stuff on a repotting day.
 
No, she just looks like her mom ;)
She has an apple tree. Girls and flowers...
Almost all of my trees are flowering, and I'm a girl, so I like her already! And I'm pretty sure if you ask my husband, he's seen me with that same look she has on her face. ;)
 
Back
Top Bottom