sorce
Nonsense Rascal
Are there no HVAC techs doing bonsai?
I always thought this would be a good tool for heavy bending.
Maybe a little raffia and wax paper to keep the bark intact.
Different size attachments for different size tubing (branches).
One could even rip copper tube lengthwise to support the outside of the bend, and leave it on after for support. Ends tied intact.
The ratcheting takes no energy to make a bend. With small increments possible.
One could make a few clicks every few days for difficult bends.
Just food for thought. Ideas?
Sorce
I always thought this would be a good tool for heavy bending.
Maybe a little raffia and wax paper to keep the bark intact.
Different size attachments for different size tubing (branches).
One could even rip copper tube lengthwise to support the outside of the bend, and leave it on after for support. Ends tied intact.
The ratcheting takes no energy to make a bend. With small increments possible.
One could make a few clicks every few days for difficult bends.
Just food for thought. Ideas?
Sorce